Spanning Tree Link Type Point To Point. What is a Spanning Tree? For a Layer 2 Ethernet network to function properly, only one active path can exist between any two stations Multiple active paths among end stations cause loops in the network
layer2RSTP和MSTP IT閱讀 from www.itread01.com
The "link-type" in STP is applied by the duplex mode, if the negotiation of switchports are full duplex, then, they will be "point-to-point" and if the negotiation of switchports are half duplex, then, they will be "shared" (for example, a switch connected to a hub) With this detail (in shared type), we can prevent rapid transitions to Forwarding state.
layer2RSTP和MSTP IT閱讀
Syntax spanning-tree link-type {point-to-point|shared} Description Specifies the link type of the interface, which is normally derived from the duplex setting of the port All, Checking in with a request for feedback regarding use of the spanning-tree link-type point-to-point command and its uses spanning-tree link-type Use the spanning-tree link-type Interface (Ethernet, Port Channel) Configuration mode command to override the default link-type setting determined by the port duplex mode, and enable RSTP transitions to the Forwarding state
Spanning Tree Scaler Topics. Use the spanning-tree mode rapid-pvst global configuration mode command to enable Rapid PVST+ Spanning Tree Protocol (STP) is a Layer 2 link management protocol that provides path redundancy while preventing loops in the network
Minimum Spanning Tree (MST) Algorithm in Data Structure Simplilearn. For a Layer 2 Ethernet network to function properly, only one active path can exist between any two stations Syntax spanning-tree link-type {point-to-point|shared} Description Specifies the link type of the interface, which is normally derived from the duplex setting of the port